Siemens siprotec 7SJ63 - Overview of the Masking Features of the User Defined Informations

Appendix
A-96 7SJ63 Manual
C53000-G1140-C120-1
A.8 Overview of the masking features of the user defined informations
Type of Information Source Destination CFC Task level
Binary Inputs Function Keys CFC Binary Outputs LED CFC Measurement PLC1 (slow) PLC (fast) Interlocking
• Annunciation:
Single Point
– SP_Ev Single Point Indication Event ––––– –––––
– SP Single Point Indication ON/OFF X –XXXX –XX–
– SP Single Point Indication Open/Close X –XXXX –XX–
Double Point
– DP
Double Point Indication (Breaker indication
“00” =
not valid/transmitted as
“3”)
X –X– – X
X
1
)
XX
X
2
)
– DP_I
Double Point Indication (Breaker indication “00” =
intermediate/transmitted as
“0”)
X –X– – X
X
1
)
XX
X
2
)
Output Slow
– OUT Output Indication Event ––––– –––––
– OUT Output Indication ON/OFF ––XXXX
X
1
)
XX
X
2
)
– OUT Output Indication Open/Close ––XXXX
X
1
)
XX
X
2
)
Output Fast
– OUT Protection ON/OFF ––XXXX–XX
X
2
)
– OUT Protection Open/Close ––XXXX–XX
X
2
)
Tagging
– IntSP_ Ev Internal Single Point Indication Event ––––– –––––
– IntSP Internal Single Point Indication ON/OFF –XXXXX
X
1
)
XX
X
2
)
– IntSP Internal Single Point Indication Open/Close –XXXXX
X
1
)
XX
X
2
)
– IntDP Internal Double Point Indication (Breaker indication
“00” = not valid/transmitted as “3”)
––X––X
X
1
)
XX
X
2
)
– IntDP_I Internal Double Point Indication (Breaker indication
“00” = intermediate/transmitted as “0”)
––X––X
X
1
)
XX
X
2
)
Tap Changer
– TxTap Transformer Tap Changer X –––– – ––––
• Control Commands without feedback:
Single Controls
– C_S ON/OFF ––XX–X–XXX
– C_S Open/Close ––XX–X–XXX
Single Controls negated
1
) Only for measurement setpoints (is processed cyclically every 600 ms); do not use for binary inputs.
2
) Only for commands (is triggered by commands only).
www . ElectricalPartManuals . com