Siemens siprotec 7SJ63 - Measurements

SIPROTEC 4 Devices
4-12 7SJ63 Manual
C53000-G1140-C120-1
4.3.2 Measurements
The measured values that are registered are divided into the following categories for
display in DIGSI
®
4 or on the HMI of the device:
q Primary values, based on the measured secondary values and the settings entered
for the current transformers and voltage transformers.
q Secondary values, which are the measured values or are derived from the mea-
sured values.
q Percentage values, relative to nominal ratings.
q Other values including thermal values and user-defined values.
q Statistics values.
k452.gif
Figure 4-6 DIGSI
®
4 Measured value display, Example
Display in DIGSI
®
4 To display the measured values using the DIGSI
®
4 2QOLQH control panel:
• Select 0HDVXUHPHQW in the navigation window. The measured value groups ap-
pear in the data window.
• Double click on a group, for example 3ULPDU\9DOXHV.
• Double click on the next item in the data window, 2SHUDWLRQDOYDOXHVSUL
PDU\ in the example. The date and time appear.
• Double click on the date and time, and the measured values appear.
www . ElectricalPartManuals . com