Siemens siprotec 7SJ63 - General Interrogation; Spontaneous Messages

Operators Tools
7-117SJ63 Manual
C53000-G1140-C120-1
tory. For details, see the “DIGSI
®
4 Device Operation” Handbook, order no. E50417–
H1176–C097, Sub-section 9.4.
When all of the desired message groups have been saved on the PC, they can be
erased from the device as described above.
Of course, you can erase the saved data from the hard drive of your PC as every file.
7.1.1.6 General Interrogation
From PC with
DIGSI
®
4
The present condition of a SIPROTEC
®
4 device can be retrieved by using DIGSI
®
4.
The messages are found by double-clicking on $QQXQFLDWLRQ(see Figure 7-2),
double-clicking on *HQHUDO,QWHUURJDWLRQ, and double-clicking on the date and
time that appear in the right window. All messages are shown along with the present
status.
7.1.1.7 Spontaneous Messages
From PC with
DIGSI
®
4
The spontaneous annunciations that can be displayed via DIGSI
®
4 are refreshed im-
mediately, an event or status change occur.
Find the message groups by clicking on $QQXQFLDWLRQ (Figure 7-2).
Double click 6SRQWDQHRXV$QQXQFLDWLRQ in the data window. The date and time
appear in the data window. By double clicking on them, the Spontaneous Annunciation
window opens, as shown in the following figure. Each entering message appears im-
mediately, without requiring that an update be initiated.
Figure 7-13 DIGSI
®
4 Spontaneous Annunciation Window — Example
:
:
www . ElectricalPartManuals . com