Requirements
Connection Establishment to SINAMICS S120
SINAMICS S120 at Technology CPU Entry ID: 21767896
V1.0 Edition 10/28/05 12/58
Copyright © Siemens AG 2005 All rights reserved
SINAMICS S120 und Technologie-CPU V2.0-SP1__05-10-28_13-20_e.doc
Figure 3-2 DIP switches for setting the Profibus address
The Profibus address can be set according to the following diagrammatic
representation:
Figure 3-3 Setting the Profibus address (address 3)
Note
As default setting of the Profibus address, address 126 is set in the
parameter p0918 of SINAMICS S120. To avoid access problems caused
by an unknown Profibus address during commissioning, the address
should be preset via DIP switches prior to commissioning (e.g.: address
3).
To Next Page
Loading...
Need help?
General