SINAMICS S120 at Technology CPU
Entry ID: 21767896
V1.0 Edition 10/28/05 2/58
Copyright © Siemens AG 2005 All rights reserved
SINAMICS S120 und Technologie-CPU V2.0-SP1__05-10-28_13-20_e.doc
Table of Contents
Table of Contents ......................................................................................................... 2
Question ........................................................................................................................ 3
How can the SINAMICS S120 drive system be commissioned with the
configuration tools of the technology CPU? .................................................
3
Answer .......................................................................................................................... 3
The instructions and notes listed in this document provide a detailed
answer to this question. ...............................................................................
3
Requirements................................................................................................................ 4
1 Setup of the SINAMICS S120 Training Case ................................................ 4
1.1 General setup ................................................................................................... 4
1.2 Components of the SINAMICS S120 training case .......................................... 5
1.3 Interconnecting the DRIVE-CLiQ components ................................................. 5
1.4 Hardware wiring of the components ................................................................. 7
2 Supported Firmware Versions of SINAMICS S120 ...................................... 9
2.1 Characteristic features during the operation of SINAMICS S120 ..................... 9
2.2 Firmware versions supported by S7T Config.................................................. 10
3 Connection Establishment to SINAMICS S120.......................................... 11
3.1 Connecting the hardware components ........................................................... 11
3.2 Setting the Profibus address........................................................................... 11
3.3 Establishing online connection ....................................................................... 13
3.3.1 Creating a STEP 7 project in the SIMATIC Manager ..................................... 13
3.3.2 Basic configuration of SINAMICS S120 in HW Config.................................... 13
3.3.3 Activating “Capability of SIMATIC PC station routing” in NetPro.................... 17
3.3.4 Establishing the online connection to SINAMICS S120.................................. 21
4 Data Backup of SINAMICS S120.................................................................. 23
4.1 Basics of data management at SINAMICS S120 ........................................... 23
4.2 Data access via the S7T Config configuration tool ......................................... 23
4.3 Backing up data at SINAMICS S120 .............................................................. 25
4.3.1 Data backup on the compact flash card ......................................................... 25
4.3.2 Data backup in a STEP 7 project.................................................................... 29
Commissioning SINAMICS S120............................................................................... 32
5 Preparing SINAMICS S120........................................................................... 32
5.1 Connecting hardware components ................................................................. 32
5.2 Establishing online connection ....................................................................... 32
5.3 Restoring factory settings ............................................................................... 33
6 Commissioning SINAMICS S120................................................................. 35
6.1 Automatic configuration of the DRIVE-CLiQ components .............................. 35
To Next Page
Loading...
Need help?
General