Siemens SITOP series - Page 121

Working with the library
7.3 WinCC Comfort/Advanced
SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
Function Manual, 11.2018, A5E37763954-09-76
121
Step number
Instruction
7 In the same way add two trends for each of the UPS8600 modules. When selecting the trend tags, ensure
that the correct HMI tag is mapped:
For example, the following HMI tags should be mapped:
UPS6800 module 1: UPS1_Trend_SOC, UPS1_Trend_Pcharge
UPS8600 module 2: UPS2_Trend_SOC, UPS2_Trend_Pcharge
Select left side axis for SOC and right side axis for Pcharge.
Note
Follow the same procedure for PSU8600 Single Power Supply Device where one trend has
to be created.