Siemens SITOP series - Input Specifications

SIMATIC STEP 7 function blocks
5.7 FB SITOP_PSU8600_Output
SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
Function Manual, 11.2018, A5E37763954-09-76
37
5.7
FB SITOP_PSU8600_Output
Function principle
The block reads the output-specific data of PSU8600/CNX8600 from the global DB for data
exchange and supplies it at its output parameters.
On request, the block writes output-specific data into the PSU8600/CNX8600.
Note
For S7-300/400
Input parameters are different for S7
-300/400 controllers. For addressing data type HW_IO,
refer to the section
Data type HW_IO (Page 20).
Block diagram
Figure 5-13