Siemens SITOP series - Installation Procedures

SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
Function Manual, 11.2018, A5E37763954-09-76
5
Warranty and liability
1
Note
The
application examples are not binding and do not claim to be complete with regard to
configuration, equipment or any contingencies. The application examples do not represent
customer
-specific solutions. They are only intended to provide support for typical
applications, you are responsible for the correct operation of the described products. These
application examples do not relieve you from responsibilities of using, installing, operating
and servicing the equipment safely and professionally. When using the
se application
examples, you recognize that we are not liable for any damage/claims beyond the liability
clauses described.
We reserve the right to make changes to these application examples at any time and without
prior notice. If there are any deviations
in the recommendations provided in this application
example and other Siemens publications, for example catalogs, the contents of the other
documents shall have priority.
We do not accept any liability for the information contained in this document. Any claims
against us – based on whatever legal reason – resulting from the use of the examples,
information, programs, engineering and performance data etc., described in this application
example shall be excluded. Such an exclusion shall not apply in the case of mandatory
liability, for example under the German Product Liability Act ("Produkthaftungsgesetz"), in
case of intent, gross negligence, or injury of life, body or health, guarantee for the quality of a
product, fraudulent concealment of a deficiency or breach of fundamental contractual
obligations ("wesentliche Vertragspflichten").
The compensation for damages due to a breach of a fundamental contractual obligation is,
however, limited to the foreseeable damage, typical for the type of contract, except in the
event of intent or gross negligence or injury to life, body or health. The above provisions do
not imply a change of the burden of proof to your detriment. Any form of duplication or
distribution of these application examples or excerpts hereof is prohibited without the
expressed consent of Siemens AG.