Siemens SITOP series - Protection and Monitoring Features

SIMATIC STEP 7 function blocks
5.10 FB SITOP_PSU8600_MainUnitSingle
SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
48 Function Manual, 11.2018, A5E37763954-09-76
5.10
FB SITOP_PSU8600_MainUnitSingle
Function principle
This block is used for SITOP PSU8600 with single output only. The block reads the main
module specific data from the global DB for data exchange and supplies it at its output
parameters.
On request, the block writes main module specific data first into Cyclic Output Memory area
(if address is provided) and then into the PSU8600 device.
Block diagram
Figure 5-19