Working with the library
7.3 WinCC Comfort/Advanced
SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
122 Function Manual, 11.2018, A5E37763954-09-76
Configuring alarms displays
Activating the alarms display
To activate the alarms, follow the steps below:
Table 7- 8
In the "Project tree", open your project.
2 Open "Runtime settings" of the HMI, click "Alarms" tab.
3 Enable the "S7 diagnostic alarms" and "With event text" checkboxes.
Note
When configuring an S7
-300/400 controller in TIA Portal, you also need to activate the S7
diagnostic alarm on the controller side. For more details, see Configuration of Messages and
Alarms in WinCC (TIA Portal)
(
https://support.industry.siemens.com/cs/ww/en/view/62121503).
To Next Page
Loading...
