Siemens SITRANS F M MAG 5000 CT - Operator Menu Setup

Service and maintenance
7.2 Technical support
SITRANS F M MAG 5000/6000
46 Operating Instructions, 01/2010, SFIDK.PS.026.G1.02
Power on transmitter
OK ⇒ 1.2.1
1.2.2 Check cables/conndections
Check connection board
Check pins in transmitter multiplug
Not OK ⇒ correct fault
OK ⇒ 2.1 2 Check cables/conndections
Check connection board
Check pins in transmitter multiplug
Not OK ⇒ Correct fault
Yes ⇒ 2.1.1 2.1 Output readings OK?
No ⇒ 2.1.2.
2.1.1 Dispaly defective Replace display
2.1.2 Transmitter defective Replace transmitter
Note
Sensor check list
Check list for sensors are included in the respective sensor operating instructions.
7.2 Technical support
CAUTION
Repair and service must be carried out by approved Siemens Flow Instruments personnel
only.
Note
Siemens Flow Instrument defines sensors as non-repairable products.
Technical Support
If you have any technical questions about the device described in these Operating
Instructions and do not find the right answers, you can contact Technical Support:
● Via the Internet using the Support Request:
Support request (http://www.siemens.com/automation/support-request
)
● Phone: +49 (0) 180 5050 222
Further information about our technical support is available in the Internet at
Technical support (http://support.automation.siemens.com/WW/vi
ew/en/16604318)