Siemens SITRANS F M MAG 5000 CT - Factory Settings; Transmitter Factory Settings

Appendix
B.1 Factory settings
SITRANS F M MAG 5000/6000
92 Operating Instructions, 01/2010, SFIDK.PS.026.G1.02
Menu item Parameter Factory
settings
Options More info
• Batch
compensation
0 -100 ... +100 m3
• Batch counter
Down Up, down
• Time constant
0.1 s 0.1 ... 30 s
Frequency Off 500 Hz, 1 kHz, 5 kHz, 10 kHz
• Time constant
5 s 0.1 ... 30 s
Digital
output -
freque
ncy
(Page 80)
Pulse On
•
Pulse polarity
Positive Positive, negative
•
Pulse width
66 ms 64 μs 130 μs, 260 μs, 510 μs, 1.0 ms, 2.0 ms, 4.1
ms, 8.2 ms, 16 ms, 33, ms, 66 ms, 130 ms, 260
ms, 520 ms, 1.0 s, 2.1 s, 4.2 s
• Volume/pulse
Dimension-
dependent
Dimension-dependent
• Time constant
0.1 s 0.1 ... 30 s
Digital
output -
pulse
(Page 79)
External input External input Off Batch
1)
, reset totalizer, freeze output, forced
output, off
• Batch
Start Start, hold/continue, stop, Qmax 2
External
inp
ut
(Page 83)
Sensor
characteristics
Correction factor 1 0.85 ... 2.00
Sensor
character
isti
cs
(Page 84)
Language Language English English, German, French, Danish, Swedish,
Finnish, Spanish, Russian, Italian, Portuguese,
Polish
Language
mode
(Page 79)
Operator menu Primary field Flow rate Flow rate, Totalizer 1, Totalizer 2
Title/subtitle lines Flow rate Flow rate, Flow rate %, Qmax, Totalizer 1,
Totalizer 2, Totalizer 1 reset, Totalizer 2 reset,
Batch start/paused/stop, Batch cycle counter,
Batch cycle counter reset, Sensor size, Sensor
type, Error pending, Status log, Tag No.
Operator
menu setu
p
(Page 78)
1)
: Available on MAG 6000 only.