Siemens SITRANS FMS500 - Connecting the sensor

Cable speci󹪝cations
• Only use cables with at least the same degree of protection as the sensor to install the sensor.
• The line length from the cable gland to the terminals must be kept as short as possible. Line
loops in the terminal box must be avoided.
• To guarantee the IP67 degree of protection, use cables with the required speci󹪝cations.
WARNING
Protective conductor terminal
The required cable is min. AGW16 or 1.5 mm
2
Cu.
WARNING
Wire insulation
For 󹪝eld wiring installation: Ensure that the national requirements of the country in which
the 󹪞owmeters are installed is met.
See also
Cable data (Page48)
5.2 Connecting the sensor
Before you start
• Read the Safety notes (Page9)
• Read the Basic safety notes: Installing/mounting
• Read the Basic safety notes: Connecting
Connecting
5.2Connecting the sensor
SITRANS FMS500
28 Operating Instructions, 01/2024, A5E52677520-AA