Siemens SITRANS FMS500 - Page 30

4. Cut o󹪜 the black wire on the coil cable. Fit coil and electrode cable through the cable glands.
5. Connect coil cable ① and electrode cable ② in the corresponding terminals on the terminal
blocks. Tighten all terminal screws with maximum torque: 0.5Nm.





















6. Connect the coil and electrode cable shields and grounding cables to the terminal board by
using grounding lugs.
Connecting
5.2Connecting the sensor
SITRANS FMS500
30 Operating Instructions, 01/2024, A5E52677520-AA