Installing/mounting
4.6 Installation instructions
FSS200 clamp-on sensors
28 Installation Manual, 08/2017, A5E36255466-AC
Figure 4-4 Direct mount (Pipe shown from above in 12 o'clock position)
The following items will be needed to mount the sensors (most materials are supplied):
● Flat blade screwdriver
● Mounting frames or mounting tracks
● Tape, chalk and a ruler or measuring tape
● Mounting straps
● Spacer bar
● Mounting guide (for Direct mount)
● Ultrasonic coupling compound and/or coupling pads
● Sensors (matched set)
The available mounting strap kits are listed below. Each kit comes with up to two band sizes
to cover its designated pipe diameter range and a spacing guide for Direct mount. In most
cases, the kits come with the mounting hardware.
50.8 mm (2-inch) to 177.8 mm (7-inch)
50.8 mm (2-inch) to 330.2 mm (13-inch)
7ME396000SM20 330.2 mm (13-inch) to 609.6 mm (24-
#188 (2) #280 (2)
7ME396000SM30 609.6 mm (24-inch) to 1219.2 mm (48-
#152 (4) #312 (4)
To Next Page
Loading...
