Siemens SITRANS FSS200 - Wizard Sensor Setup Procedure; Installing Sensors in Reflect Mount

Installing/mounting
4.6 Installation instructions
FSS200 clamp-on sensors
30 Installation Manual, 08/2017, A5E36255466-AC
4.6.3
Wizard sensor setup procedure
Referring to the Operation Instuction manual for your transmitter, use the Wizard sensor
setup procedure to set up the clamp-on sensors for your unit.
4.6.4
Installing sensors in Reflect mount
Reflect mount - Sensor installation using mounting frames and spacer bar
1.
Use the Wizard setup procedure to program the transmitter for the sensors that were
selected.
2. After receiving the spacing number index from the transmitter, make a note of the number
displayed then prepare the pipe surface area where the sensors will be mounted.
Before continuing refer to the Reflect mount installation diagram example below.
①
Sensor clamping screw
⑥
Spacer bar pin and reference hole
②
Customer pipe
⑦
Mounting strap
③
7ME39600*** Mounting Frame
⑧
Larger pipes may need additional mount-
ing straps
④
Spring Clip (not present on some mounting
frame models)
⑨
Orientation for Single path sensor at the 9
o'clock position
⑤
Spacer bar
⑩
Orientation for Dual path sensor at the 10
and 2 o'clock positions
Figure 4-6 Reflect mount