Connecting
5.4 Sensor wiring
FSS200 clamp-on sensors
Installation Manual, 08/2017, A5E36255466-AC
49
Preparing coaxial sensor cable
Note
IMPORTANT
Make sure the cable
gland ① and NPT Adapter ② have been threaded onto the sensor
cable BEFORE beginning to strip cable.
Prepare unterminated coaxial cable ends as follows:
1. Strip unterminated outer jacket
③ to shown lengths (mm/in).
2. Trim exposed inner shield
④ and dielectric to shown length (mm/in) to expose the center
conductor
⑤.
3. Fold back exposed inner shield
④ over outer jacket ③ and trim dielectric ⑥ and center
conductor
⑤ to shown lengths (mm/in).
To Next Page
Loading...
