Additional Installation Instructions
B.2 Mounting tracks for Size A and B sensors
FSS200 clamp-on sensors
Installation Manual, 08/2017, A5E36255466-AC
97
The Direct mount configuration uses a set of two track rail assemblies; one for each sensor,
installed 180° apart on the pipe. The set includes:
● Reflect mode track assembly - This track rail includes the tension screw and REF hole to
position one sensor.
● Direct mode track assembly - This track rail has number index holes for inserting an index
pin to position the other sensor.
Note
A pin will be inserted into the hole designated by the number index on the Direct mode
track rail to position one of the sensors (see
⑩ in figure below).
To SITRANS FST030 transmitter
7ME3950 series sensor downstream
7ME39600M series mounting track
7ME3950 series sensor upstream
7ME39600M series mounting track
Figure B-7 Direct Mount 180° opposed with Mounting Tracks
To Next Page
Loading...
