3 INSTALLATION
24
SITRANS FX300
www.siemens.com/flow 06/2009 - SFIDK.PS.050.F2.02 A5E02100423
3.4.6 Turning the display
Turn the display as follows:
• Disconnect the power supply from the measuring device.
• Unscrew the cover in front of the display 1 from the connection housing.
• Pull the display 2 carefully a few centimetres out of the anchor fitting and turn it to the
required position 3.
• Press the display onto the spacer pins 4, until it clicks.
• Turn the cover with gasket 5 back onto the housing and tighten it by hand.
DANGER!
All work on the device electrics may only be carried out by appropriately trained personnel. The
regional occupational health and safety directives must always be observed.
INFORMATION!
If the measuring device is installed in a vertical pipe, you will have to turn the display by 90
°
; if
installed below a pipe, turn 180
°
.
Figure 3-6: Turning the display
MA_Siemens_Sitrans_FX300_R02_en_PRT.book Page 24 Monday, June 22, 2009 8:17 AM
To Next Page
Loading...
