Siemens SITRANS FX300 - Page 52

6 OPERATION
52
SITRANS FX300
www.siemens.com/flow 06/2009 - SFIDK.PS.050.F2.02 A5E02100423
(available if Maes.Inst =
Mass, see menu item
1.1.3)
kg
Unit ↑...^
Select totalizer unit for mass flow measurement
0000000000
kg ↑…↑...↑...^
Enter preset totalizer value
Reset yes /
Reset no ↑...^
Reset totalizer /
Do not reset totalizer/
Disp. off /
Disp. on ↑...^
Display totalizer /
Do not display totalizer
3.3 HART settings
3.3.1 Poll. Adr.
→
000
0 – 15
↑…→↑...→↑...^
Enter HART polling address for "Multidrop operation"
3.3.2 HART SV
→
Total Flow ^ HART secondary variable
3.3.3 HART TV
→
Temp. ^ HART tertiary variable
Density ^
3.3.4 HART 4V
→
Density ^ HART quaternary variable
Temp. ^
3.4 Set fluid and medium
3.4.1 Fluid 1
→
Set fluid type
Gas ↑... Gas
Liquid. ↑... Liquid
Steam ↑...^ Steam
3.4.2 Medium
→
Set medium
(available if Fluid = Gas or
Liquid, see menu item
3.4.1)
Custom ↑... Customer medium
(available if Fluid = Steam,
see menu item 3.4.1)
Sat.Steam ↑...^ Saturated steam
Custom
1 Density check
3.5 Set pressure, temperature and density
3.5.1 T-sensor
→
Internal temperature sensor
No ↑... No temperature sensor available
Yes ↑...^ Temperature sensor available
3.5.3 Sat.P/T
→
(verfügbar wenn FLUID =
DAMPF, siehe Menüpunkt
3.4.1)
Density calculation for saturated steam
Sat. T ^ Density calculation for saturated steam with the
saturated temperature
3.5.4 Temp. Opr.
→
Operating temperature
°C
Unit ↑...^
Set temperature unit
0000000.0
°C ^
Operating temperature
Disp. on /
Disp. off ↑...^
Display temperature /
Do not display temperature
Level Designation Selection / entry Explanation
MA_Siemens_Sitrans_FX300_R02_en_PRT.book Page 52 Monday, June 22, 2009 8:17 AM