Siemens SITRANS FX300 - Page 55

OPERATION 6
55
SITRANS FX300
www.siemens.com/flow06/2009 - SFIDK.PS.050.F2.02 A5E02100423
(available if Maes.Inst =
Volume, see menu item
1.1.3)
m
3
Unit ↑...^
Select totalizer unit for volume flow measurement
0000000000
m
3
↑…↑...↑...^
Enter preset totalizer value
Reset Yes /
Reset No ↑...^
Do not reset counter/
reset counter
Disp. off /
Disp. on ↑...^
Do not display totalizer
Display totalizer /
(available if Maes.Inst =
Norm. Vol., see menu
item 1.1.3)
m
3
norm
Unit ↑...^
Select totalizer unit for standard volume flow
measurement
0000000000
m
3
norm ↑…↑...↑...^
Enter preset totalizer value
Reset Yes /
Reset No ↑...^
Do not reset totalizer/
Reset totalizer
Disp. off /
Disp. on ↑...^
Do not display totalizer
Display totalizer /
(available if Maes.Inst =
Mass, see menu item
1.1.3)
kg
Unit ↑...^
Select totalizer unit for mass flow measurement
0000000000
kg ↑…↑...↑...^
Enter preset totalizer value
Reset Yes /
Reset No ↑...^
Do not reset totalizer/
Reset totalizer
Disp. off /
Disp. on ↑...^
Do not display totalizer
Display totalizer /
3.2.9 E.tot. on
→
(available if Meter Type =
Gross Heat, see menu
item 5.4.1, service menu)
Energy totalizer
Tot. on ↑... Start totalizer
Tot. off ↑...^ Stop totalizer (value is held)
3.2.10 Energ.Unit
→
(available if Meter Type =
Gross Heat, see menu
item 5.4.1, service menu)
Set unit for heat energy
kJ
Unit ↑...^
Set unit for heat energy
0000000000
kJ ↑…↑...↑...^
Enter preset totalizer value
Reset No /
Reset Yes ↑...^
Do not reset heat energy/
Reset heat energy
Disp. on /
Disp. off ↑...^
Display heat energy /
Do not display heat energy
3.3 HART settings
3.3.1 Poll. Adr.
→
000
0 – 15
↑…→↑...→↑...^
Enter HART polling address for "Multidrop operation"
3.3.2 HART SV
→
HART secondary variable
Total Flow ↑...
Energy ↑...^
#available if Meter
Type = Gross Heat
(menu item 5.3.1,
service menü)
Level Designation Selection / entry Explanation
MA_Siemens_Sitrans_FX300_R02_en_PRT.book Page 55 Monday, June 22, 2009 8:17 AM