Siemens SITRANS FX300 - Page 61

OPERATION 6
61
SITRANS FX300
www.siemens.com/flow06/2009 - SFIDK.PS.050.F2.02 A5E02100423
3.5 Pressure, temperature and density
3.5.1 T-sensor
→
Internal temperature sensor
No ↑... No temperature sensor available
Yes ↑...^ Temperature sensor available
3.5.2 P-sensor
→
Pressure sensor
Intern ↑... Internal pressure sensor
--- ↑...^
No pressure sensor available
3.5.4 Temp. Opr.
→
Operating temperature
°C
Unit ↑...^
Set temperature unit
0000000.0
°C ^
Operating temperature
Disp. on /
Disp. off ↑...^
Display temperature /
Do not display temperature
3.5.5 Pres. Opr.
→
Operating pressure
Pa
Unit ↑...^
Set pressure unit
0000000.0
Pa ^
Operating pressure
Disp. on /
Disp. off ↑...^
Display pressure /
Do not display pressure
3.5.6 Dens. Opr. Density at operating pressure and operating
temperature
kg/m
3
Unit ↑...^
Set density unit
00011.0000
kg/m
3
^
Operating density
3.5.7 Temp.Norm .
(available if Maes.Inst =
Norm. Vol., see menu
item 1.1.3)
00000020.0
°C ↑…↑...↑...^
Enter normal temperature
Unit as 3.5.4
3.5.8 Pres.Norm
(available if Maes.Inst =
Norm. Vol., see menu
item 1.1.3)
00000000.0
Pa ↑…↑...↑...^
Enter normal pressure
Unit as 3.5.5
3.5.9 Dens. norm
(for unknown gases using
standard volume flow
measurement, see menu
items 1.1.3, 3.4.1 and
3.4.2)
00001.2900
kg/m
3
^
Enter density for reference conditions (pressure and
temperature)
3.5.10 P-Excit. V
(available if P-Sensor =
Internal, see menu item
3.5.2)
0005.00000
V ^
Exciting voltage of pressure sensor
3.5.11 P-Sen.P1V1
(available if P-Sensor =
Internal, see menu item
3.5.2)
Pressure sensor:
1st calibration point
0001.00000
P1 kg/cm
2
g ↑…↑...
↑...^
0002.00000
V1 mV ↑…↑...↑...^
Level Designation Selection / entry Explanation
MA_Siemens_Sitrans_FX300_R02_en_PRT.book Page 61 Monday, June 22, 2009 8:17 AM