Page 10 SITRANS LU10 – INSTRUCTION MANUAL 7ML19985AN02
mmmmm
Installation
Interconnection
Before interconnecting system components to the SITRANS LU10 terminals, verify all
components have been installed in accordance with the associated product instruction
manuals.
Connect all associated equipment cable shields to the SITRANS LU10 shield connections.
To avoid differential ground potentials, do not connect cable shields to ground (earth)
elsewhere. Insulate (tape) cable shields at all shield junctions to prevent ground loops.
All field wiring must have insulation suitable for at least 250 V.
Hazardous voltage is present on transducer terminals during
operation.
OFF
230 V
115 V
100 V
200 V
SYN C
P12
SITRANS LU 10 __________
display
scope connections
optional
SmartLinx
module
board A
SW1
voltage
selection
EPROM
optional
TIB-9
terminal block
board B
To Next Page
Loading...
