Siemens sitrans LU10 - Programming and Operation

7ML19985AN02 SITRANS LU10 – INSTRUCTION MANUAL Page 15
mmmmm
Programming
Programming
Operator programmable features are identified by a Point Number and Parameter
Number. The Point Number refers to the Transducer (vessel) Number, Relay Number, mA
Output Number, or TS-3 Number as identified by the Point Type indicators. Parameter
Numbers have a preset Parameter Value for each Point Number.
Programming is accomplished by altering the preset Parameter Values as required to
obtain the RUN mode operation desired. All operator programmable features are defined
in the Quick Start Parameters, Application Parameters, and Enhancement Parameters
sections of this instruction manual.
Display
In the PROGRAM mode, the Point Type, Point Number, Parameter Number, and Parameter
Value (as well as a variety of other programming information) may be viewed.
Note that many indicators are specific to certain programming conditions and therefore,
all indicators are not displayed at any given time
all indicators are not displayed at any given timeall indicators are not displayed at any given time
all indicators are not displayed at any given time.
Parameter Number the programmable feature the Parameter Value pertains to.
Point Type the Point Number refers to a Transducer, Relay, mA Output, TS-3, or
Breakpoint.
LU SAM Bank
Number
identifies the LU SAM the Relay Number displayed pertains to.
Point Number the Transducer, Relay, mA Output or TS-3 # the Parameter Value pertains to.
Parameter Value the current value of the Parameter Number for the Point Number displayed.
Units indicates the Parameter Value is displayed in: m, cm, mm, ft, in, or %.
Invalid Entry indicates the value entered is questionable.
Auxiliary Function indicates Auxiliary Function access (applies to only some Parameter
Numbers).
Scroll Access Tag indicates the Parameter Value may be scroll accessed.
PROGRAM mode indicates the PROGRAM mode is accessed.
Point in Service indicates the Point Numbers which will be scanned in the RUN mode.
Transducer
Relay
Analog Output
TS-3
Index
Point Type
LU SAM Bank
Number
Point
Number
Parameter
Value
Units
Auxiliary
Function
Point in Service
PROGRAM
mode
Parameter
Number
Invalid Entry
Scroll Access
Tag