7ML19985AN02 SITRANS LU10 – INSTRUCTION MANUAL Page 43
mmmmm
Enhancement Parameters
Enhancement Parameters
This section identifies all SITRANS LU10 operator programmable features designed for
altering operation to suit individual operator preferences or overcome measurement
difficulties.
Typically, these parameters are only altered as directed by the Troubleshooting Guide . If
RUN mode performance requires improvement, access and alter the following
parameters as required. Otherwise, proceed to Operation.
When an Enhancement Parameter is altered, return to the RUN mode to verify the
When an Enhancement Parameter is altered, return to the RUN mode to verify the When an Enhancement Parameter is altered, return to the RUN mode to verify the
When an Enhancement Parameter is altered, return to the RUN mode to verify the
performance desired is achieved before making any other changes.
performance desired is achieved before making any other changes. performance desired is achieved before making any other changes.
performance desired is achieved before making any other changes.
Data Logging Parameters (P300 and P302)
View the maximum temperature recorded in the RUN mode.
Parameter Category Purpose Page
Data Logging to view previous maximum Temperature records 50
Profile Records intended for use by Siemens Milltronics Service personnel 51
Installation Records to identify length of service and power failure occurrence 54
Range Calibration to compensate for measurement offset and/or sound velocity 55
Temperature Compensation to override automatic temperature compensation features 57
Rate to override Measurement Response (P003) 59
Measurement Verification to override Measurement Response (P003) 61
Scanning to override automatic scanning delay or use Aux. Transducer 63
Display Parameters to override the preset display operating characteristics 65
SmartLinx Parameters communications 67
Echo Processing to troubleshoot false echo detection 68
Advanced Echo Processing intended for use by Siemens Milltronics Service personnel 70
Test Parameters intended for use by Siemens Milltronics Service personnel 78
Measurement Parameters to verify Application Parameter programming 80
Master Reset to reset numerous Parameter Values 81
P300 (V) TEMPERATURE, TRANSDUCER MAX
Use this feature if vessel temperature is monitored by an Ultrasonic /
Temperature transducer to view the highest temperature recorded (in °C).
values: -50 to 150
To Next Page
Loading...
