Page 14 SITRANS LU10 – INSTRUCTION MANUAL 7ML19985AN02
mmmmm
Installation
Power
Before making the power connection, ensure proper voltage selection.
Before making the power connection, ensure proper voltage selection. Before making the power connection, ensure proper voltage selection.
Before making the power connection, ensure proper voltage selection.
Never operate the SITRANS LU10 with the enclosure lid open, or with the ground
Never operate the SITRANS LU10 with the enclosure lid open, or with the ground Never operate the SITRANS LU10 with the enclosure lid open, or with the ground
Never operate the SITRANS LU10 with the enclosure lid open, or with the ground
(earth) wire disconnected.
(earth) wire disconnected. (earth) wire disconnected.
(earth) wire disconnected.
Ensure that any connected alarm or control equipment is disabled until satisfactory
Ensure that any connected alarm or control equipment is disabled until satisfactory Ensure that any connected alarm or control equipment is disabled until satisfactory
Ensure that any connected alarm or control equipment is disabled until satisfactory
system operation and performance is verified.
system operation and performance is verified. system operation and performance is verified.
system operation and performance is verified.
The equipment must be protected by a 15 A fuse or circuit breaker in the
The equipment must be protected by a 15 A fuse or circuit breaker in the The equipment must be protected by a 15 A fuse or circuit breaker in the
The equipment must be protected by a 15 A fuse or circuit breaker in the
building installation.
building installation. building installation.
building installation.
A circuit breaker or switch in the building installation, marked as the disconnect
A circuit breaker or switch in the building installation, marked as the disconnect A circuit breaker or switch in the building installation, marked as the disconnect
A circuit breaker or switch in the building installation, marked as the disconnect
switch, shall be in close proximity to the equipment and within easy reach
switch, shall be in close proximity to the equipment and within easy reach switch, shall be in close proximity to the equipment and within easy reach
switch, shall be in close proximity to the equipment and within easy reach
of the operator.
of the operator. of the operator.
of the operator.
50 51
L2/N
52
L1
SW1 switch shown in the
‘OFF’ position. Select
appropriate voltage.
100/115/200/230 V
50/60 Hz
select voltage via SW1.
To Next Page
Loading...
