Page 58 SITRANS LU10 – INSTRUCTION MANUAL 7ML19985AN02
mmmmm
Enhancement Parameters
P727 (G) SCAN DELAY
Use this feature to adjust the delay before the next point is scanned. Enter the
amount of delay in seconds. This value is automatically altered when
Measurement Response (P003) is altered. (See
Technical Reference
Measurement Response).
values: 0.000 to 60.00
P728 SHOT DELAY
Use this feature if acoustic noise within the vessel is causing measurement
difficulties. Enter the delay between transmit pulse shots (in seconds). This
value is automatically altered when Measurement Response (P003) is altered.
See
Technical Reference
Measurement Response.
values: 0.1 to 4.0
P729 (V) SCAN TIME
View the time elapsed (in seconds) since the point displayed was last scanned.
This value may be viewed as an Auxilliary Reading in the Run mode (especially
useful when setting up Smart Scan, P720). See
Operation
Keypad.
values: 0.000 to 9999
To Next Page
Loading...
