A5E33701270 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL Page 17
mmmmm
Operation - PDM
Step 3 – Vessel Shape
1. In this step, there are two options: Linearization Table and Curve Table. Breakpoints
will be entered in the same manner regardless of the table type selected, however a
different algorithm is used for Curve Table, to smooth the lines between breakpoints.
For example, use Curve Table when vessel sides are more rounded rather than
straight angles. Make a selection and click on NEXT.
Step 4 - Ranges
1. Modify parameters as required.
2. Click on Linearization to set breakpoints.
3. In the Linearization window click on the appropriate Breakpoint tab to open the
dialog window.
To Next Page
Loading...
