85
SIVACON S8 Planning Principles – Conforming to standards and design-verified
2
3
4
5
6
7
8
9
10
11
1
9.4 Declarations of conformity and
certificates
With a Declaration of Conformity, the manufacturer of the
low-voltage switchboard confirms that the requirements of
the directive or standard referred to in this declaration have
been fulfilled.
Further information about such declarations of conformity
and certificates (Fig. 9/4, and Fig. 9/5 to Fig. 9/7 are exam-
ples of such documents) can be obtained from your Sie-
mens contact.
CE marking / EC declaration of conformity
The CE marking is a label affixed under the sole responsibil-
ity of the manufacturer. The Declaration of Conformity
confirms compliance of products with the relevant basic
requirements of all EU Directives of the European Union
(European Community, EC) applicable to this product.
Low-voltage switchboards – named power switchgear and
controlgear assemblies in the product standard
IEC 61439-2 – must comply with the requirements of the
Low Voltage Directive 2006/95/EC and the
EMC Directive 2004/108/EC. The CE marking is a mandatory
condition for placing products on the markets of the entire
European Union.
The new Low Voltage Directive 2014/35/EU and EMC
Directive 2014/30/EU must be transferred in national law by
the EU member states up to the 20th of April, 2016. At that
time a new declaration of conformity is provided.
To Next Page
Loading...
Need help?
General
