Siemens Synova FC330A - Page 29

e1973c-4
02.2004
25
Fire & Security Products
Siemens Building Technologies Group
Enable single zones
1. Enter the number of a zone to be ena-
bled (e. g. 2).
 Display shows 
 With a running timeout after which the
zone is automatically enabled.
2. Enter another zone number to enable
or press
F1
to enable the zone before
the timeout has expired.
 Display shows 
for a few seconds
or
3. Press
hm
to go back to the submenu.
 Display shows 
Enable a range of zones
1. Enter the first number of a zone range
to be enabled (e. g. 2).
 Display shows 
2. Enter the last number of the zone range
(e. g. 5).
 Display shows 
 With a running timeout after which the
zone range is automatically enabled.
3. Press
F1
to enable all zones before the
timeout has expired.
 Display shows 
for a few seconds
or
4. Press
hm
to go back to the submenu.
 Display shows 
Enable all disabled zones
1. Enter 555 to enable all disabled zones,
no matter if all zones, a range of zones
or single zones were disabled.
 Display shows 
 With a running timeout after which all
zones are automatically enabled.
2. Press
F1
to enable all zones before the
timeout has expired.
 Display shows 
for a few seconds
or
3. Press
hm
to go back to the submenu.
 Display shows 
MONITORING zone ###, wait.
(F1 /hm = enabling) next zone?
ENable zones:
> all zones ENABLED
timeout /hm: menu Stop: end operating
ENabling: 1. detector ’zone’
(1.1) 2. detector ’element’
3. ConTrol ’zone’
4. All Fire Ctrl ’zones’
ENable zone range ### to ###
> confirm LAST zone no.?
MONITORING zones ###−###, wait
(F1 /hm = enabling) > LAST zone
ENable zones:
> all zones ENABLED
timeout /hm: menu Stop: end operating
DISabling: 1. detector ’zone’
(2.1) 2. detector ’element’
3. ConTrol ’zone’
4. All Fire Ctrl ’zones’
MONITORING zone ###, wait
(F1 /hm = enabling) > LAST zone
ENable zones:
> all zones ENABLED
timeout /hm: menu Stop: end operating
DISabling: 1. detector ’zone’
(2.1) 2. detector ’element’
3. ConTrol ’zone’
4. All Fire Ctrl ’zones’