Siemens Synova FC330A - Page 28

e1973c-4
02.2004
24
Fire & Security Products
Siemens Building Technologies Group
Disable all zones
1. Enter 555 to disable all zones in the
building.
 Display shows 
2. Enter 99 for permanent disabling.
 Display shows 
or
"
Enter the desired disabling time in full
hours (e. g. 2).
 Display shows 
3. Press
St
to finish the zone disabling
procedure.
 Display shows 
 The yellow LED isolation is on.
Viewing disabled zones
Several zones disabled
 Display shows 
1. Press key
F1
to open list.
 Display shows 
2. Press key to view details.
 Display shows 
 After last zone has been displayed, sy-
stem turns back to overview.
 Display shows 
Zone reactivation procedure
1. Press
St
.
 Display shows 
2. Select option 1.  1.  1.
 Display shows 
 The yellow LED isolation is off.
zone ### − ### SELECTED
> hours DISABLED? (99=permanent)
hm: back to menu Stop: end operating
Permanent disabling
zone ### permanent DISABLED
(hm = end) new zone no.?
hm: back to menu Stop: end operating
Disabling for a few
hours
zone ### DISABLED for ## hours
(hm = end) new zone no.?
hm: back to menu Stop: end operating
parts of system DISABLED total:###
WED
21.7.00 15:00
parts of system DISABLED total:###
WED
21.7.00 15:00
display ISOLATIONS: total:###
(key: ↓ = forward / ↑ = backward)
F1: next section hm/Stop: end operating
display ISOLATIONS: total:###
zone ### − ### permanent DISABLED
↓: forward F2:ext info ↑: backwards
parts of system DISABLED total:###
WED
21.7.00 15:00
SELECT: 1. ENabling
(main menu) 2. DISabling
3. INFO polling
4. other functions
ENable zone: (range ### to ###)
> zone no.? (555 = all)
hm: back to menu Stop: end operating