What does 'Fault on BMS?communication' mean on Siemens Measuring Instruments and how to troubleshoot it?
If your Siemens Measuring Instruments display 'Fault on BMS?communication', it indicates a communication fault on the BMS communication. Check the connection from the PC to the control panel.
What does 'Missing telegram at LON dev. ##' mean on Siemens Measuring Instruments and how to fix it?
If your Siemens Measuring Instruments display 'Missing telegram at LON dev. ##', it means a telegram is missing at the LON device. Press ’Acknowledge’ then ’Reset’ on the operating panel.
What does 'External power supply fault' mean on Siemens Measuring Instruments and how can I fix it?
If your Siemens Measuring Instruments display 'External power supply fault', it indicates a fault on the power supply input ’K50’. Check input ’K50’ on K3X...
What does 'Ext. Fault: Mains power Ext. Fault: Battery Ext. Fault: power supply' mean on Siemens Measuring Instruments and how to troubleshoot?
If your Siemens Measuring Instruments display 'Ext. Fault: Mains power Ext. Fault: Battery Ext. Fault: power supply', it indicates an external fault in the mains power, battery, or power supply. Check the device connected to ’K6’ (Z3I1000 etc.).
What does 'External FAULT' mean on Siemens Measuring Instruments and how to address it?
If your Siemens Measuring Instruments display 'External FAULT', it means an external fault input has been activated. Check the connected devices.
What does 'Error:Buffer empty, Mess. ###, Timer ###' mean on Siemens Measuring Instruments and how to resolve it?
If your Siemens Measuring Instruments display 'Error:Buffer empty, Mess. ###, Timer ###', it indicates a software problem. To resolve this, unpower the system and then re-power it. If the message reappears, replace the main board K3X...
Why do Siemens Measuring Instruments show 'RESTART due to watchdog: Part #'?
If your Siemens Measuring Instruments display 'RESTART due to watchdog: Part #', it's due to a software or hardware error. Reset the system. If this occurs frequently, replace K3X...
What does 'ConTrol zn ###/##: NO RESPONSE' mean on Siemens Measuring Instruments and how to fix it?
If your Siemens Measuring Instruments display 'ConTrol zn ###/##: NO RESPONSE', it indicates that the displayed device (AB... or ABI... or CB...) is missing. Check the device or its wiring.
What to do if Siemens Measuring Instruments display 'RESTART due to power down'?
If your Siemens Measuring Instruments display 'RESTART due to power down', it means the system stopped because of disconnection by ‘low discharge protection’ (mains failure and battery
What to do if Siemens Measuring Instruments show '24V supply too high'?
If your Siemens Measuring Instruments display '24V supply too high', it's because the battery voltage is too high. To solve this, check the mains voltage. If it's okay, replace K3X...
General| Measurement Principle | Coriolis |
|---|---|
| Protection Class | IP67 |
| Material | Stainless steel |
| Communication | HART, PROFIBUS PA |
| Outputs | 4-20 mA, pulse/frequency |
| Display | LCD |
| Output Signal | 4-20 mA, pulse/frequency |
| Process Temperature | -50 to +150 °C (-58 to +302 °F) |
To Next Page
