Copyright © Sigicom AB 2021
4. Configuration and Installation
4.1. Configurations and Settings
The customer’s INFRA Net account is pre-set from Sigicom prior to
delivery and cannot be changed by the customer. Contact Sigicom
Support if this needs to be changed.
4.1.1. INFRA Net Communication Schedule
Through INFRA Net you can set which hours the C22 shall connect
(when monitoring is on). The connection will start within the first 15
minutes (randomly distributed) of each configured hour.
If there are communication difficulties, the unit will continue to connect
to INFRA Net until successful, using a time delay pattern to minimize
power consumption.
4.1.2. Flight Mode
C22 can be set in flight mode where INFRA Net (and other)
communication is inhibited, see section 5.8.2 for this configuration.
4.1.3. Configuration Menu
For setup of monitoring parameters, go to the Monitoring configuration
menu, see section 5.8.1.
4.1.4. INFRA Net Messages
All messages are handled through INFRA Net under the Messages tab.
To Next Page
Loading...
Need help?
General