Copyright © Sigicom AB 2021
5.8.3. Clock Set
Time synchronization is handled automatically (see section 6.3), so
setting the clock manually is normally not needed.
For manual setting, select “Clock set” by pressing
→ Settings and actions → Clock set.
Note! To change the Clock settings, Monitoring must be OFF and
Communication mode set to Flight mode.
Use to step forward and arrow keys ( or ) to change a value.
Finish with the key.
Note! C22 will reboot after the clock is changed.
5.8.4. Clock Format
Time can be displayed in either 12- or 24-hour format, which is
configured by this selection. This configuration is only for the instrument,
INFRA Net is not affected by this.
To Next Page
Loading...
Need help?
General