Laboratory centrifuge Sigma 1-14
Version 08/2012, Rev. 3.14 of 11/08/2017 • sb
Translation of the original operating manual, part no. 0700002
Pos: 92 /100 Sig ma/100 BA Zentrif ugen Sigma (S tandardmod ule)/061 Betrieb_S pincontrol Basic/ 061 Betrieb==== ======= ======= ======================= @ 27\mod_140532031379 4_68.docx @ 1 93669 @ 1 @ 1
6 Using the centrifuge
Pos: 93 /100 Sig ma/100 BA Zentrif ugen Sigma (S tandardmod ule)/061 Betrieb_S pincontrol Basic/ 061-0010 Erste Inbetrieb nahme @ 27 \mod_1405320 314744_68.docx @ 193683 @ 2 @ 1
6.1 Initial start-up
• Before the initial start-up, please ensure that your centrifuge is properly
set up and installed (see chapter 5 - "Set-up and connection").
Pos: 94 /010 Uni versalmodule/ Leerzeile @ 0\mod_120 2116244500_ 0.docx @ 114 @ @ 1
Pos: 95 /100 Sig ma/100 BA Zentrif ugen Sigma (S tandard module)/061 Betrie b_Spincontrol B asic/061-0020 Einschalten @ 2 7\mod_14053 20315792_68.d ocx @ 1936 97 @ 2 @ 1
6.2 Switching the centrifuge on
• Press the mains power switch.
The display then illuminates. The centrifuge is ready for operation.
Pos: 96 /010 Uni versalmodule/ Leerzeile @ 0\mod_120 2116244500_ 0.docx @ 114 @ @ 1
Pos: 97 /100 Sig ma/100 BA Zentrif ugen Sigma (S tandardmod ule)/061 Betrieb_S pincontrol Basic/ 061-0020- 0010 Öffnen u nd Schließen des Deckels @ 2 7\mod_14053 20316807_68.d ocx @ 193711 @ 3 @ 1
6.2.1 Opening and closing the lid
The lid can be opened if the centrifuge is at a standstill.
• Press the lid key in order to open the lid.
The centrifuge cannot be started if the lid is opened.
• To close, press with both hands slightly on the lid until the lid lock is
locked.
Do not place your fingers between the lid and the housing when closing
the lid. Risk of crushing!
Pos: 98 /010 Uni versalmodule/ Leerzeile @ 0\mod_120 2116244500_ 0.docx @ 114 @ @ 1
Pos: 99 /100 Sig ma/100 BA Zentrif ugen Sigma (S tandardmod ule)/061 Betrieb_S pincontrol Basic/ 061-0020- 0020 Einsetze n von Rotoren und Zubehör @ 27\mod_1405 320317739_6 8.docx @ 1937 25 @ 3 @ 1
6.2.2 Installation of rotors and accessories
Pos: 100 /100 Sig ma/110 BA Ze ntrifugen Sigma (Proj ekte)/1-1 4_1-14K/061 Betrieb/060-00 20-0020-0010 Einsetzen des Ro tors_1-14_1-1 4K @ 28\mod_ 14053208104 51_68.docx @ 1 95461 @ 4 @ 1
6.2.2.1 Installation of the rotor
1 Safety lock
2 Snap-on lid
3 Rotor fastening nut
4 Motor shaft
5 Angle rotor
Fig. 3: Installation of rotor and rotor lid
To Next Page
Loading...
