Pos: 129 /100 Sig ma/110 BA Ze ntrifugen Sigma (Proj ekte)/1-1 4_1-14K/061 Betrieb/Spincontr ol Basic/061-0 030-0070-003 0 Dauerbetrieb ( nur 1-14) @ 28\mod_1405 320830467_68. docx @ 195615 @ 4 @ 1
6.3.7.3 Continuous run
During the continuous run, the runtime of the centrifuge is unlimited and
must be stopped manually. The centrifuge accelerates during the
continuous run until the set speed is reached.
• To start the continuous run, press the select key until the time unit
flashes on the display.
• Press the down-key (arrow key) until the display switches from "00:10"
to "--:--".
After 99 min 59 sec, any additional runtime will no longer be displayed, but
the centrifugation will continue.
• To stop a continuous run, press the start/stop key. The centrifugation
will end.
• Enter a runtime. The centrifugation will end after this time.
Pos: 130 /010 Uni versalmodule/ Leerz eile @ 0\mod_12 02116244500 _0.docx @ 114 @ @ 1
Pos: 131 /100 Sig ma/110 BA Ze ntrifugen Sigma (Proj ekte)/1-1 4_1-14K/061 Betrieb/Spincontr ol Basic/061-0 030-0090 Soft start- und Softst op-Funktionen ( nur 1-14) @ 2 8\mod_14053 20831467_68.d ocx @ 195629 @ 3 @ 1
6.3.8 Softstart and softstop function
The softstart function is used to extend the acceleration time, whereas the
softstop function is used to extend the deceleration time. The current
combination is shown on the display.
• To activate the softstart and softstop functions, press the select key
repeatedly until "Soft-stop/start" flashes in the upper left part of the
display.
• Press the arrow keys until "Soft-stop/start on" is displayed. The softstart
and softstop functions are now activated.
• Press the select key until "Soft stop on" is displayed. Only the softstop
function will be active and the centrifuge will start at normal speed.
• Press the select key until "Soft off" is displayed. The softstart and
softstop functions are now deactivated.
The data will be accepted immediately and saved after approx. 20 seconds.
You can also change the settings as described above during a
centrifugation run.
Pos: 132 /010 Uni versalmodule/ Seitenwechsel @ 0\mod_12 02116244312_0 .docx @ 105 @ @ 1
To Next Page
Loading...
