Laboratory centrifuge Sigma 1-14
Version 08/2012, Rev. 3.14 of 11/08/2017 • sb
Translation of the original operating manual, part no. 0700002
Pos: 133 /100 Sig ma/110 BA Ze ntrifugen Sigma (Proj ekte)/1-1 4_1-14K/061 Betrieb/Spincontr ol Basic/06 1-0030-0100 Ro torauswahl 1-1 4 @ 28\mod_14 05320832335_ 68.docx @ 195 643 @ 3 @ 1
6.3.9 Rotor selection
In the delivery status of the centrifuge, the rotor 12094 is preselected. If
another rotor is installed the configuration must be changed, so that the
allowed maximum speed of the rotor can be reached.
• To select another rotor, press the "select" key and hold it.
• Press the upper arrow key three times until the rotor selection menu is
displayed, then release the select key.
• Choose the number of the installed rotor out of the following list, by
pressing the arrow keys:
• Press the select key to confirm the input.
The RCF value will be adjusted automatically to the selected rotor.
The rotor selection will be saved under the corresponding program
number.
Pos: 134 /010 Uni versalmodule/ Leerzeile @ 0\mod_12 02116244500 _0.docx @ 114 @ @ 1
Pos: 135 /010 Uni versalmodule/ Leerzeile @ 0\mod_12 02116244500 _0.docx @ 114 @ @ 1
Pos: 136 /100 Sig ma/100 BA Ze ntrifugen Sigma (St andardmo dule)/061 Betr ieb_Spincontrol Basic/061-004 0 Ausschalt en @ 27\mod_14 05320321633 _68.docx @ 193 767 @ 2 @ 1
6.4 Switching the centrifuge off
• Open the centrifuge when it is not in use so moisture can evaporate.
• Switch the centrifuge off by pressing the mains power switch.
Pos: 137 /010 Uni versalmodule/ Abschnittswechs el @ 0\mod _1202124514 062_0.docx @ 418 @ @ 1
Pos: 138 /010 Uni versalmodule/ Seitenwechsel @ 0\mod_12 02116244312_0 .docx @ 105 @ @ 1
To Next Page
Loading...
Need help?
General
