Laboratory centrifuge Sigma 1-14
8 Maintenance and service
Version 08/2012, Rev. 3.14 of 11/08/2017 • sb
Translation of the original operating manual, part no. 0700002
Pos: 155 /100 Sig ma/100 BA Ze ntrifugen Sigma (St andardmo dule)/080 Wartung und Instandh altung/080-0 010-0020 Zu behör (außer 8K) @ 28\mod_14 05320618247_ 68.docx @ 1 94845 @ 3 @ 1
8.1.2 Accessories
For the care of the accessories, special safety measures must be
considered as these are measures that will ensure operational safety at
the same time!
• Immediately rinse off the rotor, buckets, or accessories under running
water if they have come into contact with any liquids that may cause
corrosion. Use a brush for test tubes in order to clean the bores of angle
rotors. Turn the rotor upside down and allow it to dry completely.
• Clean the accessories outside the centrifuge once a week or preferably
after each use. Adapters should be removed, cleaned and dried.
Do not clean the accessories in a dishwasher!
Cleaning in a dishwasher removes the anodised coating; the result is
cracking in areas that are subject to stress.
• If the rotors or accessories have been contaminated with toxic,
radioactive, or pathogenic substances, clean them immediately with a
suitable decontamination agent (depending on the type of
contamination). Take suitable precautions for your own safety if there is
a risk of toxic, radioactive, or pathogenic contamination.
• Dry the accessories with a soft cloth or in a drying chamber at
approx. 50°C.
Pos: 156 /010 Uni versalmodule/ Leerzeile @ 0\mod_12 02116244500 _0.docx @ 114 @ @ 1
Pos: 157 /100 Sig ma/100 BA Ze ntrifugen Sigma (St andardmo dule)/080 War tung und Insta ndhaltung/080-0 010-0020-001 0 Kunststoffz ubehör @ 28\ mod_1405320619 602_68.docx @ 194859 @ 4 @ 1
8.1.2.1 Plastic accessories
The chemical resistance of plastic decreases with rising temperatures (see
chapter 11.4 - "Resistance data").
• If solvents, acids, or alkaline solutions have been used, clean the plastic
accessories thoroughly.
Plastic accessories must not be greased!
Pos: 158 /010 Uni versalmodule/ Seitenwechsel @ 0\mod_12 02116244312_0 .docx @ 105 @ @ 1
To Next Page
Loading...
Need help?
General
