64
z It is possible to change the exposure timing of mirror lock-up photography.
Please set from [
Capture Settings] (P. 2 8 ) → [UP setting].
Shutter button
(Default)
After the mirror is raised, exposure will be measured by
pressing the shutter button halfway.
after 2 sec
Exposure will be measured 2 seconds after the mirror is
raised.
after 10 sec
Exposure will be measured 10 seconds after the mirror is
raised.
z When [after 2 sec] or [after 10 sec] is set and [Timer sound] in [
Camera
Settings] (P. 28) is set to [On], an electric beep will sound during the self-timer
operation. If you would like to cancel the electronic beeping sound, please set
it to [Off].
CAUTION !!
• Mirror lock up will cancel automatically, and mirror will return to its original
position, after 30 seconds. You can reactivate the mirror lock-up function by
pressing the shutter button halfway again.
WARNING !!
• If you are using this function in a strong light source, the shutter curtain may
become particularly hot by light entering through the lens. It could cause
damage or fire. Please refrain from using the mirror look-up function in such
an environment.
TIP
• It is possible to use Mirror Lock-up with remote control (Sold Separetely).
Please refer to page 78-80.
To Next Page
Loading...
