Signal SDS Series - Manual Station and Valve Operation

SDS Series
24
Quick Start Programming
MANUALLY RUN VALVES:
Valves will operate without starting pumps or master valves. A useful function for testing.
Select Valves
#00 #00 #00 #00
Use numeric keys and
< > to next valve
Set Run Time
00 : 10 : 00
Use < > keys to scroll to
the “Run Valves”display
From the current Time
and Date display scroll
TWO-WIRE
< Press Enter >
Use numeric keys to set hr:min:sec
and press enter to start
To stop valves
running
RAIN-OFF PROGRAMS:
Program Entry
< Press Enter >
Rain-Off Program
< Press Enter >
Rain-Off program
1 2 3 4 5 6 7 8
Use < > keys to
select programs
From the current Time
and Date display scroll
Program
< Press Enter >
To de-select Rain-Off repeat above steps
and use < > keys to select program
PAUSING PROGRAMS:
Same as Rain-Off, but scroll only to the “Pause Program” display, see above. Permanent
Pause is the only option.
MANUALLY START/STOP STATIONS:
MANUAL/TEST
< Press Enter >
Manual Start Prg
< Press Enter >
Use numeric keys to
select min : sec
Set Station Time
00 : 00 Ms
Use < > keys to select
different pump option
Set From / End Stn
From ## End ##
Select station numbers
from keypad
Manual Start Stn
< Press Enter >
< Master Pump >
start delay 00 : 00
To stop manual stations
Use numeric keys in min : sec if a delay
is wanted before the manual start begins
and/or
To manually advance to another station use the numeric keys for the stn number
RainOff Duration
< Permanent >
Use < > keys to select between Raining
off Permanently, or for 24/48/72/96 hrs