Silca DUO POWER - Cutting Flat Cylinder and Vehicle Keys - LEFT-HAND Carriage

Operating manual - English DUO
Copyright Silca 2 010 23
8.2 Cutting flat cylinder and vehicle keys - LEFT-HAND carriage
Fig. 30
1) Turn the clamps to find the appropriate side for securing the key (fig. 30).
2)
Loosen the knobs
(E)
by a couple of turns
.
3) Raise the lower part of the clamps and turn to the required position (fig. 24):
- Side A of the clamp: for keys to be fitted on their backs, keys with double cuts without groove and
cruciform keys (fig. 30);
- Side B of the clamp: for keys placed on their backs and having cuts with a depth of less than 3,9
mm (fig. 30);
- Side C and D of the clamp: for keys to be cut on both sides and locked on the groove (fig. 30).
D
A
B
C
D
A
B
C
DUO BRAZIL key-cutting machineDUO / DUO POWER key-cutting machine
max.42 mm
DUO BRAZIL
only with