Silca DUO POWER - Access to the Lower Part

DUO Operating manual - English
34 Copyright Silca 2 010
9.2 Access to the lower part
ATTENTION: remove the mains plug.
1) Detach the wire from the key-cutting machine socket.
2) Remove the swarf tray (S) (fig.5, page 6).
3) Before to turn the machine onto its back take the carriages externally to the end of run (left-hand car-
riage all to the left, right-hand carriage all to the right) to avoid contacts between cutter/tracer point
and clamps during movement.
4) Turn the machine onto its back firmly holding it on handles (C and H) (fig. 47).
Fig. 47
C H