Silca Unocode 399 Plus - Page 33

Operating manual - English Unocode 399 PLUS
Copyright S ilca 2010 29
f) Edit the Cutting Method
• Type of Cut
The machine can run several types of cut: NORMALE, PIANO, LASER, VERTICALE.
If provided for on the data card, the user can edit the type set by default.
N ORMAL
For conventional car and door keys.
F LAT
Mainly used for car keys w here the cut edges are rounded to
facilitate the movement of the blades when the key is put into
the lock.
L ASER
Conjunction of the cutting angles is determined automatically
by the machine, allowing cuts to be made with variable angles;
this facili tates the smooth en try of the key in to the lock,
prolonging the working life of the key.
V ERTICAL
Necessary for special keys with sm all bits (Silca art. FO19 P,
FO21P...) where a special cutter is required.
When this cutti ng method is use d a sp ecial angl ed cu tter is
needed.
• Press F1 to view the type of cut set by Silca for
the data card and the possible alt ernatives ( if
applicable).
Edit the set type of cut with
one of the al ternatives
given.
The type of cut is active
throughout the time the
machine is in use.
When the machine is
turned off the function
returns automatically to
the original setting for the
type of cut.
ATTENTION: for certain cutting methods the standard cutter U01W must be replaced with a specific
cutter.
N
P
L
V
V
F1
Current cut type
Cut type set by Silca
as original
Feasible and selectable
options for the
selected card