UNOCODE PRO Operating manual - English
10 Copyright Silca 2017
2.2 UNPACKING
To remove the machine from the packing box:
1) cut the straps with scissors and remove
2) raise the top part of the cardboard box
3) loosen the screws, both on the front and back brackets that hold the machine to the pallet
4) use the special spanner (provided in the tool kit), to loosen the nuts on the machine’s feet
5) remove the metal brackets and re-tighten the nuts on the feet.
6) check the contents in the box, that should comprise with the following:
1 UNOCODE PRO
key-cutting machine
1
set of documents, including: an operating manual, a spare parts list and a guarantee
1
power supply cable
1
tool kit
Note: we strongly recommend you keep the packing intact for future transportation
2.3 MACHINE HANDLING
When the UNOCODE PRO has been unpacked, place it directly on its workbench; this operation should be carried out by
at least two people.
Take care to lift the machine firmly holding the base, and no other part.
ATTENTION: never lift the machine by holding the keyboard stand (fig. 8).
Fig. 8
To Next Page
Loading...
