Operating manual - English UNOCODE PRO
Copyright Silca 2017 55
6.10.7 SERIAL PORT
Check that the machine’s display indicates OFF.
Fit the special (Z4) serial test connector (accessories provided) to the
machine’s serial port.
Press START and check that the machine’s display indicates OFF to
ON.
Note: if the ON/OFF transition is not made, contact Silca’s Technical
Assistance Dept.
6.10.8 MACHINE ZERO POINTS
With the use of regulating templates (Ch.1.5 "Accessories provided", page 8) the machine provides a ‘self-setting’ proce-
dure. These procedures must be carefully carried out following the descriptions and illustrations indicated below.
The table below indicates the situations where the Machine Zeroes function must be activated.
Fit the template (Z1) in the place of the cutter; (to remove the cutter
read the instructions in Ch.8.3).
EVENT
MACHINE ZEROES CALIBRATING
CLAMPS CUTTERS
Replacement of
photocells
YES YES NO
Replacement of
the electronic board
YES YES NO
Replacement of
the Optical Reader unit
NO YES NO
Replacement of sensors
YES YES NO
Replacement of the cutter
shaft
YES YES NO
Replacement of the ball
screws
YES YES NO
To Next Page
Loading...
