Operating manual - English UNOCODE PRO
Copyright Silca 2017 45
6.8.2 SYNCHRONISE MACHINE DATE/TIME (UTP VERSION ONLY)
Note: this operation is necessary only when the machine mother board battery has been replaced.
Note: do not turn the machine off during data transfer. The machine must be on.
Date/Time can be synchronised only by the SRS program and an internet connection.
After replacing the battery proceed as follows:
1) Turn the machine on and wait for an ALARM message to appear.
2) Turn the machine off.
3) Turn the machine on again and proceed with Date/Time synchronisation.
Synchronisation procedure:
- Connect a PC serial or USB cable to the key-cutting machine.
- Start the SRS program and select the machine model; click on “Next”.
- Click on the function “
Machine Date/Time synchronisation when mother board battery is replaced
” and then on
“Next”.
- Select the communication port (COM) and click on “Read”; the machine serial number will appear in the Serial
Number field.
- Click on the “Prepare” button and wait a few minutes for the operation to end.
To Next Page
Loading...
