Silca Unocode PRO - Troubleshooting and Message Reference

UNOCODE PRO Operating manual - English
66 Copyright Silca 2017
6.13 MESSAGES
6.13.1 ATTENTION MESSAGES
• The entered data card number is not available in the machine’s data base.
• The entered cuts cannot be carried out (see Ch.6.5.1, page 34).
• This message appears when the cutter must be changed with one that is compatible to the type of cuts required
for the entered data card number.
• This clamp is not available in the machine’s data base.
• This cutter is not available in the machine’s data base.
• This adapter is not available in the machine’s data base.
• The entered data card number requires a type of cut that is not available in the machine’s data base.
• The minimum distance from the key stop position overlaps the first cut on the key (Ch.6.11, page 61).
Data card
not available!
Non-feasible
combination!
ATTENTION!!
Install cutter:
U01W
Clamp not
available!
Cutter not
available!
Adaptor not
available!
Type of cut
not available!
MIN. Parameter of
DISTANCE FROM STOP
is incompatible with
selected card!