UNOCODE PRO Operating manual - English
46 Copyright Silca 2017
6.9 GAUGING
The following components on the machine have a specific ‘self-setting’ procedure with the use of regulating templates
(Ch.1.5 "Accessories provided", page 8):
-CLAMPS
- CUTTERS
ADAPTERS provided as optionals do not require calibrating. However, if necessary adjustments can be made to the
cutting data, according to the procedures described in Ch.6.4 "Copy with adjustments", page 21.
In the circumstances listed below (see events) it may be necessary to re-set one or all of the clamps and/or cutters that
the user has in possession. This operation is semi-automatic and requires close attention to the instructions listed below.
From the initial screen press MENU then F1 to enable the func-
tion.
•Clamps ->
•Cutters ->
• Adapters ->
EVENT
MACHINE
ZEROES
CALIBRATION
CLAMPS CUTTERS
Replacement of photocells
YES YES NO
Electronic board replacement
YES YES NO
Replacement of the Optical Reader unit
NO YES NO
Replacement of sensors
YES YES NO
Replacement of the cutter shaft
YES YES NO
Replacement of the ball screws
YES YES NO
Clamp replacement Cutter side
(with a new one of the same type)
NO NO NO
Clamp replacement Lector side
(with a new one of the same type)
NO NO NO
Re-sharpening of existing cutter and/or cutter
replacement (with a new one of the same type)
NO YES YES
Installation of optional clamps
NO YES
(if applicable)
NO
To Next Page
Loading...
