Operating manual - English UNOCODE PRO
Copyright Silca 2017 17
6 OPERATING GUIDE
Introduction
The Operating Guide below explains how to use the UNOCODE PRO without a Personal Computer.
All operations to manually use the key-cutting machine are explained step by step.
The programs available for Personal Computers connected to the key-cutting machine are able to transmit data for
cutting, reading or decoding keys.
Programs for Personal Computer eliminate manual procedures of certain functions, once the data has been transmitted
to the machine it bypasses some of the operating guides screens.
When the UNOCODE PRO is used with a Personal Computer, the operating guide does not change its displays logic,
with the exception of all the screens that are rendered unnecessary.
6.1 INITIAL OPERATIONS
When the key-cutting machine has been placed on its workbench and connected to the mains (Ch.3.3, page 11), proceed
as follows:
1)
make sure that the emergency button is not turned on
.
2) turn the machine on by means of the main switch that is located on the back of the machine.
3) to check or alter the parameters for use of the machine, consult the "OPTIONS" menu (Ch.6.11, page 61).
When the machine is turned on the display shows the following screen:
Fig. 19
Besides the first 4 icons relating to the main functions, listed on the left, the following information appears:
• Name of the key-cutting machine
• Serial number of the key-cutting machine
• SW version: machine program version
• DB version: version of the cutting card Database on board the machine
•Date
•Time
• Flashing word MENU (press MENU to view the other main functions)
• Machine in UTP mode (Unlimited Token Plan)
GREEN:
days of use exceed the minimum warning point set in the Options => UTP Settings (Ch.6.11.2)
YELLOW:
days of use are below the minimum warning point set in the Options => UTP Settings (Ch.6.11.2)
RED:
days of use have expired or are about to expire (Ch.6.11.2)
UNOCODE PRO
UNOCODE PRO UTP
To Next Page
Loading...
