Silca Unocode PRO - Access to Back Compartment; Access to Bottom Compartment

UNOCODE PRO Operating manual - English
80 Copyright Silca 2017
8.8 ACCESS TO BACK COMPARTMENT
To gain access to the back compartment, proceed as follows:
1) turn the machine off and unplug it from its power supply cable.
2) remove the vacuum system’s connector (U2) (fig. 54).
3) unscrew the 6 (M1) screws that secure the back panel (fig. 54) thus removing it.
Fig. 54
8.9 ACCESS TO BOTTOM COMPARTMENT
To gain access to the bottom compartment, proceed as follows:
1) turn the machine off and unplug it from its power supply cable.
2) remove the vacuum system’s connector (U2) (fig. 54).
3) turn the machine on its back side.
4) remove the machine’s bottom panel by unscrewing the 8 (L1) screws.
Fig. 55
M1
U2
L1